harrison'sblog

lofting - 1

Lofting schedule is a plan to be sure for lofting which i have to follow.

The order is important when i draw on the card board. it goes like this sheer, deck line, chine for P, C body, stem line

chine for HB.

at the first time, i did this without the order ^^, so i had to do it again.

This is the Table of offset which say each points where the every lines have to pass

Photo0556

Doing lofting... this has been failed for making fair, so i fixed this again,, not enough, but better than before

Photo0527

this picture is when i erased my Buttock 50, 200 and 400 

Photo0529

this picture is when i erased my WL 60, 100 and 200

For i made this mistake, i should spend much time drawing lines.

----------------------------------------------------------------------------------------------------

There were many problems, actually i didn't care about stem face, fair and kinky point

originally the lines have to be curved from the chine which has the same distance in P and HB from stations

for example if the chine meets buttock 50 in P and has the distance, it must have the same distance in HB.

But, thanks to number of the mistakes i could be better on it.

A thing which i have to be careful is that i need to check the distance from FP to the C body by SFD(stem face detail)

my one was bad because it didn't fit a little bit at each points.

------------------------------------------------------------------------------------------------

The body plan should be done with gathering the information from P and H, and angled transom would be drawn with 10 degrees

Photo0532

Photo0531

tool box

Making the tool box, i made a mistake on the handle that makes loose between the handle and the top of the tool box. When i chiseled on that spot, it has been broken too much areas than what i wanted on it, probably i should do chiseling on it little by little in the point of the end,

oilstone box

Photo0538

Photo0537

Photo0536

Photo0535

Photo0534

offsets sheet

https://spreadsheets.google.com/pub?key=0AiTgp27dtk-KdFVUMDY5MUdqdGJ1cEsteFo1Wk9DbXc&hl=en&output=html

download this

making oilstonebox

I am making the oilstonebox after the toolbox, there would be some problems with it, like measuring the deep of the oilstonebox incorrectly and its inside which would be put the oilstone, has to be flat with chiseling, that is difficult, i spended a lot of time for it. Maybe, i have to keep in mind that measuring dimension is important, to make a work easy.

Vox Tips & Tricks

Write your first post

Tell us a little about yourself. How’s your day going? What brought you here? What’s something you’re really excited about? If you need a little inspiration, answer the Question of the Day. Or introduce yourself to the Vox community. Click on compose to write your first post.

Display your favorite music, movies and books

Show us what you’re enjoying. You can add your favorite music, movies and books to your Vox with just a few clicks. Under the My Vox menu, click on Organize to start adding media.

Find inspiration by exploring

See what other Voxers are blogging about by visiting the Explore page. Join the conversation by commenting, leaving a [this is good] or adding people to your Neighborhood.

Only you can see this post. You may delete it at any time.